MG-Rover.org Forums banner

rover 400 bootlid

672 views 2 replies 2 participants last post by  Cooldel  
#1 ·
Hi,
Please can anyone tell me if a rover 45 saloon bootlid is the same as a rover 416 saloon apart from the obvious badges etc. I have put a dent in my 416 and have only been able to source a 45 in good condition. Thanks
 
#2 ·
I think they are pretty much the same, if you can take measurements from yours in a few places and match them up to the one you have found. also check wiring for numberplate light, chances are the connector will be the same but if its not it could be different for a reason! I would however recommend trying to get the same car though if your in doubt, try searching ebay for breaking rover 400. there's quite a few on there and a choice of colours.

http://shop.ebay.co.uk/?_from=R40&_trksid=m570&_nkw=breaking+rover+400