MG-Rover.org Forums banner
1 - 8 of 8 Posts

·
Registered
Joined
·
1,708 Posts
Discussion Starter · #1 ·
How much lower shoudl I expect my car to be with ZR springs on the mk3 200?
- 15mm?
 

·
Registered
Joined
·
456 Posts
dont bother, if you are going to upgradce the spings go for some g-max ones or if you can afford it a set of coilovers

the gmax springs can be a little sloppy i have them, but coilovers would probably be better on your roads (tooooooooo many potholes to career round!!)
 

·
Registered
Joined
·
1,708 Posts
Discussion Starter · #3 ·
I just want a minimal lower you see. 40mm would be too low for me, 20mm would be purrrrrfect.

Coilovers - I wish!
 

·
Registered
rover_25
Joined
·
1,835 Posts
ZR ones should provide about 15-20mm then, and an improved ride/handling probably. Shouldn't be too dear either.
 

·
Registered
rover_45
Joined
·
255 Posts
I have the same problem - I want to improve the handling, but a 40 mm drop is far too much.

where did you get the springs from?
 

·
Registered
Joined
·
1,708 Posts
Discussion Starter · #7 ·
From a member lad... put a thread up in the Wanted forum im sure plenty of people here have the OE springs lying in their shed
 
1 - 8 of 8 Posts
Top