MG-Rover.org Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
1,431 Posts
Discussion Starter · #1 ·
as above really please! ive got a 400 bubble shape and i need a new motor! ive got the mot and service soon so i may as well get it done at the same time! ill probably get one from the scrappies and as i havent got a haines manual i dont know where it is! can any one oblige please!? if anyone has a spare one for sale even better! cheers guys!
 

·
Registered
Joined
·
446 Posts
To get access to the washer bottle you need to remove the bumper. Once the bumper is off the washer bottle is hold by 2 bolts (or was it 3?). You could remove the whole bottle assembly from the car as it is easier to see and work while removing the pump.
 

·
Registered
Joined
·
446 Posts
If it's only the front that doesn't work, before removing the bottle check by operating it from inside the car which one is the pump for the front...there are two pumps that sit side by side at the bottom of the bottle.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top