MG-Rover.org Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
75 Posts
Discussion Starter · #1 ·
When i release the clutch when changing gear it seems to delay about an inch from being fully out, then it just pops out all the way. Im wondering if this could just be the clutch cable, this has happened more than once, only after a long drive. Also i dont think the clutch is going because it seems fine,(not slipping or showing any other real signs). Anyone shine some some light on this please.
 

·
Premium Member
Joined
·
54,941 Posts
Check the clutch pedal mechanism first. Where the pivot point is.

The was one incident recently where the mechanism broke and stopped the clutch working altogether. Far from a common occurance, but take a peek none the less.
 

·
Premium Member
Joined
·
54,941 Posts
Clutch pedal is by your feet. The pivot point is further towards the floor on the mounting bracket.
 
1 - 5 of 5 Posts
Top