MG-Rover.org Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hi everyone,

I'm new here and ive got a Rover 220 SDI 98 model. I've recently fitted a Towtrust tow bar and am having difficulty wiring the single electrics up due to not having a wiring diagram. If anyone could email me a copy it would be great. [email protected]

Or if anyone knows which wires are which,then that would be great too.

Thanks in advance

Jon.
 

·
Registered
Joined
·
1,284 Posts
Green+pink striped = Brake
Red+Orange striped = Rear illumination
Blue+yellow striped = fog
Green+White striped = RH IND
Green+Red striped = LH IND

All of the above are earthed to complete the circuits

Test connections with multimeter first!

Hope this helps

Thanks
 

·
Registered
Joined
·
10 Posts
Discussion Starter · #3 ·
Thanks for that, thats a big help.

I'm an electrical numpty,if i get a multi meter on the connections,where can i earth the other probe? I tried earlier but didnt get a reading on any connections?
 

·
Registered
Joined
·
1,284 Posts
Thanks for that, thats a big help.

I'm an electrical numpty,if i get a multi meter on the connections,where can i earth the other probe? I tried earlier but didnt get a reading on any connections?
Positive needs to go on the wire your testing and the negative needs to go on the cars body or an earth point. When the wire is powered the light will light on the car and the mulimetre should show a reading.

Thanks
 
1 - 6 of 6 Posts
Top