MG-Rover.org Forums banner
1 - 5 of 5 Posts

·
Registered
rover_25
Joined
·
1,835 Posts
Discussion Starter · #1 ·
I bought some new switches recently and was planning on having then running down the pillar, but for various reasons I'm thinking of locating them elsewhere.

I don't just want them where the normal switches are on the console, and wherever they go I want it to look like they belong there.

Do you think it would be stupid to put them inside the armrest so that when I open the lid there's a little panel with all the switches on it? Only thing is that they're nice switches and I'd rather show them off! :)
 

·
Registered
Joined
·
4,873 Posts
If you have an armrest -> how about running then down the sides of that either side of the hand brake bit..(e.g facing the centre console)

If that makes no sense its cos its stupidly early....(only few hours sleep)
 

·
Registered
rover_25
Joined
·
1,835 Posts
Discussion Starter · #4 ·
It does make sense, I'll take a look! At the moment I only have 3 - for interior neons, boot release and a start button. Would like more though if it looks good :)
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top