MG-Rover.org Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
644 Posts
Not sure about these cars but the few i have done are simliar,

most are secured at the top by a bracket were the rad is held either side.

fans need to be unplugged

top and bottom hoses removed use a bucket if you don,t want water going every were.


and the rad should lift out. ++++++then you slot new one in


re-attach hoses and fan plugs.


refill coolent 50/50 water anti freeze some cars just need to be run a few mins with expansion cap of when restarting.


On some others you need to undue bleed screws etc refer to manual someone here will know on that model.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top