MG-Rover.org Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Hello, does anyone know what the correct Ecu mems I need for a 1.1 SPI as the Ecu I have currently I believe is not the correct one for my vehicle as the idle is so poor when it’s cold. I have replaced most of the sensors and the stepper motor and it still runs poor. I also had to replace my exhaust as the catalytic converter was broken. I replaced an o2 sensor as well.

I did a compression test to check of the engine health they was all around 125-135
Thanks
James
 
1 - 3 of 3 Posts
Top