MG-Rover.org Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
i replaced the rotor arm and distributor cap on my rover 216. the haynes manual says i need to replace the bolt that holds on the rotor arm is this necessary? and if it is where can i get one. any help will be appreciated!! thanx
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #6 ·
okie dokie thanx for everyones help, if i was going to get a new bolt does anyone know where i can get one from? if theyre easy to get hold of i might aswell replace it otherwise i wont bother
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top