MG-Rover.org Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I noticed other day on my 600 that the passenger side rear pads were extremely worn down and drivers side where not. It looked like the disc on drivers side had not been used for a while.
So i decided to changed pads and once calipers were off i could see that the drivers side piston was not moving at all.
With a bit of winding in and out its started to move when pressing brakes and using handbrake so must have been slightly seized but to me, it does not seem to be doing as much work as passenger side.

Im thinking the caliper could be buggered, but would it work at all if it was. Can somebody please confirm this for me?

thanks
 
1 - 2 of 2 Posts
Top