MG-Rover.org Forums banner

Modifications to your f/tf 2010/2011

9.9K views 67 replies 33 participants last post by  COPPERKNOB  
#1 ·
Thought i would start a thread to get the mod juices flowing for the new year, what have you done to your car in the last year and what do you plan to do in 2011 to your beloved car?

Many Thanks
 
#3 ·
Hi

Just a few of my favourites in 2010 I have only had the car for half a year now and loving it.

Allen bolts in the gear surround and S/Steel start switch.

Image


Scoops

Image


And favourate The new hood.

Image


Next is to sort out the damage to my rear wing and bumper just spray work noew and thw wheels are getting a fresh paint job DIY so fingers crossed.

Ta-tar for now.
 
#4 ·
ooohh where do i start on my F

new alloys
front splitter
side intakes make my own
52mm throttle body (got)
k&n applolo air filter (got)
rear spoiler
upgrade brake lines
upgrade rear discs
mod hard roof ?????? (summer jub)
new wishbones

done so far
interior lighting
stereo inc subs
new carpet
full restore of paintwork (was matt due to neglect by previouse owner)
subframes repainted
ball joints replaced
new lamba
new rad
new groved front discs ebc green pads
rebuilt calipers

plus give wifes F a full service plus radiator
recharge aircon ect

and any thing else i missed
so another busy year
 
#5 · (Edited)
I have a few ideas running around in my head that I'm not going to share just yet ;) Current mods are listed in my sig and others planned are:

Direct Port nitrous upgrade
Inlet and exhaust systems deburred/port matched/wrapped or coated
Finish wheel refurb
Finish sound deadening
Finish A Pillar builds

Probably a load more than I can't remember right now, all listed and costed somewhere :lol:
 
#6 ·
I have just had my TF for 3 weeks, its been off the road for about 6 weeks so it has not seen any snow or grit.

so far :
Wire brushed underside and applyed a heavy coat of waxoyl to protect from the winter elements.

Resprayed heater dials in Zircon silver.
.
Fitted chrome rings for clock and oil gage.

A good wash and wax with interior clean.
 
#7 ·
Last year :

New hood with glass rear screen.
Leather seats.
Enclosed induction kit.
52mm throttle body.
TT exhaust (got it in 2009 but only fiited last March).
AP's.

This year :

Quad rear lights.
New carpets.
Braided brake hoses.
Silicone cooling hoses, if I can find someone to make them.
 
#9 ·
Already done:
Front splitter
Rear lights

To do this year
Reversing sensor (with a difference)
Low level coolant alarm

Maybe this year:
A few interior colour changes
New hood with glass rear window

Trying to stay away from:
New alloys
Sports Exhaust
 
#11 ·
Already done:
Front splitter
Rear lights

To do this year
Reversing sensor (with a difference)
Low level coolant alarm

Maybe this year:
A few interior colour changes
New hood with glass rear window

Trying to stay away from:
New alloys
Sports Exhaust
Daftest idea yet!!...........You REALLY need a nice zorst, best mod for a big silly grin everytime you go out! :D
 
#13 · (Edited)
Done in 2010 ( I got the TF in Feb)

Blueflame exhaust.
New Headgasket ( unwanted mod) :(
Seatbelt tidies
Seatbelt pads
Seatbelt clip covers
New glass screen hood
Oil, clock and Heater rings
Heater dial knobs
Body decals
Wheel centre Badges
Bonnet and boot Badges
Windscreen vents and "MG" covers
Sprayed Petrol cap surround, Hockey sticks,centre console,Airbag blank, and air vents.
Personal number plate
Glass wind deflector
DVD player
Aerial topper
Reversing camera
New Grilles all round
Blue oil and clock LEDs
Blue Dash LEDs
Blue mirror lights
Blue footwell tubes

Other than that i saved my money :wooman:
 
#17 ·
The sum of my 2010 mods:

New hood with glass screen
New Grenadine Red Handbrake Gaiter to match interior
New Battery ( :( )
'petevik' badges
Lowered Seats
Plugs and Magnecor Leads
Plastic alternator cover (was missing) + new alternator

What I want in 2011 if I ever find the cash:

Alcantara Seats/covers
Slick Shift
Zorst
Sorting out tesco rash/various minor blemishes
 
#18 ·
2010

Full SS Decat Exhaust System (Longlife)
HID Lights
New downpipe

2011

Fit these - DONE TODAY!!!
Fit wind deflector - Ready to fit when I find out how to fit it :lol:
Rust treatment & Respray - Need ÂŁÂŁÂŁÂŁÂŁ
Alloys - Need ÂŁÂŁÂŁÂŁÂŁ
Glass window & new hood - Need ÂŁÂŁÂŁÂŁÂŁ
 
#63 ·
2010

Full SS Decat Exhaust System (Longlife)
HID Lights
New downpipe

2011

Fit these - DONE TODAY!!!
Fit wind deflector - Ready to fit when I find out how to fit it :lol:
Rust treatment & Respray - Need ÂŁÂŁÂŁÂŁÂŁ
Alloys - Need ÂŁÂŁÂŁÂŁÂŁ
Glass window & new hood - Need ÂŁÂŁÂŁÂŁÂŁ
You fitted these and didn't enclose a photo ????? :drool:



Were they easy to do ?

I'm very tempted (Shhhhhhhhh don't tell Kim) :ziplip:
 
#23 · (Edited)
2010 has seen the following shiny bits aquired (since August)...

Front foglights
Electric wing mirrors and controls
Windstop
Hardtop and wiring
Replaced faded badges
Stainless underfloor coolant pipes
Stainless bolts in under-bonnet area
Mk 2 Doorcards with tweeters and oval handle surrounds
Sparkle silver centre console with matching doorcard flashes
Alloy heater control knobs
Blue LED lit interior
Sun visors
Kenwood head unit
JBL component speakers in doors and t-bar
Blaunpunkt active subwoofer behind passenger seat
Lexus style rear lights
TT exhaust (loving this the most)
Miscellaneous bits & bobs including OEM aerial, gear knob, inspection cover with flaps, uprated bulbs, floor mats and air freshener!

:faint:

For 2011, we'll be focusing on Mungos engine which has been largely neglected this year, as well as braking and further pointless shiny bits... in a fortnight he'll be getting a Complete Service fom this guy.

Grilles replaced throughout - aquired, but undecided on silver or black
LED puddle lights in doorcards
Coolant level sensor
Central locking motors
11 spoke 16" alloys (aquired)
AP front brakes (aquired)
Uprated front/rear disks/pads
52mm TB (aquired)
Taipan enclosed induction (aquired, for the fun of it)
XR3TF Side-vent scoops (aquired)
Ambient lighting for vent scoops and exhaust

Then I think we'll be done fiddling :D
 
#27 ·
2010 - stainless coolant pipes, ultra bright headlamp bulbs, LED sidelight bulbs, LED rear quad lights, alloy seatbelt holders and back plates, blue front and rear badges, 2 tone horns, stainless under bonnet bolt set. stainless hood catch bolt set, new Alpine head unit.
the neccesities - 4 new tyres, new speed sensor, full service.

2011 - le type front bumper, fit DRL's in front bumper, rear spoiler (aquired), side scoops (like R8 blade types, have to see).

future - new leather seats(blue leather),new door cards, new speakers, poly bush sets for suspension, wheel adaptors to fit different PCD wheels,......etc etc
 
#54 ·
2010 - stainless coolant pipes, ultra bright headlamp bulbs, LED sidelight bulbs, LED rear quad lights, alloy seatbelt holders and back plates, blue front and rear badges, 2 tone horns, stainless under bonnet bolt set. stainless hood catch bolt set, new Alpine head unit.
the neccesities - 4 new tyres, new speed sensor, full service.

2011 - le type front bumper, fit DRL's in front bumper, rear spoiler (aquired), side scoops (like R8 blade types, have to see).

future - new leather seats(blue leather),new door cards, new speakers, poly bush sets for suspension, wheel adaptors to fit different PCD wheels,......etc etc
Today the alloy seatbelt guide caught the edge of the drivers side seatbelt as i was putting the belt on, result a frayed seat belt, now totally B..ll.xed, so beware if you have these fitted.

Any one got a drivers side seatbelt for a TF ????

im gutted.
 
#29 ·
2010
relocate the horns near the cooling radiator
remote boot release (home made)
280 mm front disc upgrade (home made using Mini discs)
OEM rear lights cluster covers
alu pedal pads (aquired not yet installed)

in progress
aluminum heating knobs, I'm manufacturing the parts with my Mini late and Milling mach.
 
#31 · (Edited)
2010.. Tigger got...
Stainless Steel pipes,
TT exhaust
Stripes
Black side repeaters
Wheel centre graphics
Tigger topper
Tigger air freshener

2011
Chrome dial rings (got.. not fitted)
Wheel stripes (got.. not fitted)
Quad lights (got, still not bodged to fit)
New rear screen, not sure glass or another plastic one..
Tigger mats

and when I get one
Low coolant alarm
 
#32 ·
2010.. Tigger got...
Stainless Steel pipes,
TT exhaust
Stripes
Black side repeaters
Wheel centre graphics

2011
Chrome dial rings (got.. not fitted)
Wheel stripes (got.. not fitted)
Quad lights (got, still not bodged to fit)
New rear screen, not sure glass or another plastic one..
Tigger mats

and when I get one
Low coolant alarm
What about a tigger topper?? Halfords do them for ÂŁ3.49 :)
 
#36 ·
Oh dear.. where do I start... at the bank I suppose.. for a new loan!

52mm TB
Exhaust and de-cat pipe
Engine bushes
new carpets
new sun visor (or fix current one)
fix rust bubbles on a-pillar
fix scratches
new alloys?
new tyres? (once current ones wear out)
paint centre console
interior lighting
fix leather seats (two rips on driver's seat) - refurb would be ideal.
 
#40 ·
well last year i did quite a few of the 'normal' mods you know the stuff.... badges,shiney bits etc

but then got bored with that so thought i'd go a bit more extreme

Image


that wasnt really a great success so i thought i'd start again.......

Image


this one was even harder to mod as most of the shiney bits had already been very tastefully done by Dan, but not one to give up easily i tried again ..........

Image


didn't really work out the second time either so i've returned her back to normal ( with a bit of extra shiney added) and hopefully i'll resist the urge to try extreme modding this year :D

Image


so as far as extreme mods go, you could say i've been there got the T-shirt.........














oh bugger, i actually DO have the T-shirt :rofl:


Image