MG-Rover.org Forums banner
1 - 6 of 6 Posts

· Registered
mg_tf
Joined
·
508 Posts
I've just tried this and assuming yours is a pre face lift model, I found it a bit of a challenge. At first I thought it was a bayonet fitting as I could turn it but it wouldn't come out then it just pulled out. I think it's just a push fit but as mine hadn't ever been out, I think it was just stuck, once I got it out it would go in and out without a problem.


135795
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top