MG-Rover.org Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1
Hi,

Is it possible to getan induction kit for a diesel Rover 220 (bubble shape) I heard that you get even more of a performance increase when you get a kit for a diesel. I haven't managed to find one though.

I am looking for the cheapest and easiest way to find a bit more power

Any ideas.

Thanks:bgrin2:
 

·
Registered
Joined
·
3,699 Posts
cheapest and easiest power you will get is a decat. take the cat off and bash out the insides of it.

next thing to do is to increase fueling..... you got the SDi or SD?
 

·
Registered
Joined
·
10,841 Posts
A good filter would be a little beneficial, ive got a K+N panel filter on mine, and it does the job perfect. You will only get a little power increase if any, but all helps.
You wont get a deep grunt like a petrol, it will be a "whoosh" sound :)
You can get universal cone filters from K+N or Greenstuff etc... ,measure the air intake hose and see which one will fit.

IIRC its 85mm, but measure it anyway!
 

·
Registered
Joined
·
21,962 Posts
ricc said:
if you get an enclosed kit its more of a tearing noise..... jet plane style (H)
Watch the pre-oiled filters, make sure the oild does not contaminate the MAF.

Cheers
Skelo
 

·
Registered
Joined
·
10,841 Posts
Skelo said:
Watch the pre-oiled filters, make sure the oild does not contaminate the MAF.

Cheers
Skelo
i dont think my sensor works? :err: Well not as it should, its got narly half of the spade thingy missing!, been like that now for year n half.

Dont clean the sensor too hard! haha
 

·
Registered
Joined
·
21,962 Posts
Stu C said:
i dont think my sensor works? :err: Well not as it should, its got narly half of the spade thingy missing!, been like that now for year n half.

Dont clean the sensor too hard! haha
Then again it could be the 25/45 where the MAF is more critical.

Cheers
Skelo
 
1 - 11 of 11 Posts
Top