MG-Rover.org Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
835 Posts
Discussion Starter · #1 ·
Hi Folks,

A slight problem with the temp heater control on the TF tonight. After setting it to hot and the car warming up, I tried to turn it down, however the knob felt 'mushy' when trying to turn it, and no matter where you now set it, its on the max temp setting. I seem to remember seeing this problem somewhere else, but cant remember the solution. It seems as though the knob and its attached gear has unattached itself from the mech inside?

Any suggestions?

Cheers

Ian
 

· Registered
Joined
·
835 Posts
Discussion Starter · #7 ·
That sounds more like it, because I've got the Mike Satur Aluminium heater knobs, so it must be something inside, rather than the knob itself. I'll have a wee dig about see what I can see!

Thanks

Ian
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top