MG-Rover.org Forums banner

heater problem

761 Views 3 Replies 3 Participants Last post by  Andy400
hi guys. my heater only runs on 3 and 4 settings but only for a couple of minutes before stopping.leave it for a couple of minutes and it will run again any ideas .many thanks
1 - 4 of 4 Posts
hi guys. my heater only runs on 3 and 4 settings but only for a couple of minutes before stopping.leave it for a couple of minutes and it will run again any ideas .many thanks

loads on this do a quick search ,for resistor pack.
spoon feeding is only good for babies ;)
LOL....

Just had the same issue.

Resistor pack.... Mine was £14.00 from that internet auction site.

Cause was the motor burning out.... I had that out too and could see and feel that it was VERY hard to turn. New one spins freely. Just awainting the reisitor pack to arrive before I put it all back together!
LOL....

Just had the same issue.

Resistor pack.... Mine was £14.00 from that internet auction site.

Cause was the motor burning out.... I had that out too and could see and feel that it was VERY hard to turn. New one spins freely. Just awainting the reisitor pack to arrive before I put it all back together!
you where riped off most it should cost is £7 inc p&p
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top