MG-Rover.org Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3,950 Posts
Do those just screw on..? Would MG gear knobs fit a rover 200 (bubble shape)...? I'm looking to change my gear knob and gaiter.
 

·
Registered
Joined
·
14,750 Posts
You need to make sure.
All 200s were Screw on...so you need a gear knob from a zr that has a screw on one...earlier zrs.

The push on ones will not fit your 200. Gear gaitor is a straight swap.
 

·
Registered
other_manufacturer
Joined
·
34,938 Posts
michaelperrin said:
You need to make sure.
All 200s were Screw on...so you need a gear knob from a zr that has a screw on one...earlier zrs.

The push on ones will not fit your 200. Gear gaitor is a straight swap.
make sure you dont round off the thread while taking off the old one though :err:

Mike - I've PM'ed you about a few bits - did you get it? i'l try and catch you on MSN tomorrow
 

·
Registered
Joined
·
14,750 Posts
No...didnt get it?

My inbox was full yesterday, and still is on the verge of being full again now...i need to delete some soon!
 
1 - 7 of 7 Posts
Top