MG-Rover.org Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,195 Posts
Discussion Starter #1
I am gonna replace the Crankshaft Position Sensor... Is there anything I should be aware of or is it as simple as the haynes manual says?
 

·
Registered
Joined
·
3,309 Posts
Its a bit of a pain to find and reach! Also, it can be difficult to find the hole to relocate the new part. Think the (single) bolt holding it is 8mm - but I could be wrong as its a couple of years since I fitted one.
 
1 - 2 of 2 Posts
Top