MG-Rover.org Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter #1
The metal section of clutch pipe that comes off the rubber section in the engine bay on my F is looking a bit corroded. As I'm doing the brake pipes I'll have all the tools to do the clutch pipe too, but does anyone know what diameter the pipe is?
 

·
Formerly StationMiek
Joined
·
504 Posts
Old thread bump
I think it's 1/2" in diameter ... however, it could be metric in size (like the Americans use), and be in millimetres. I've bought some 1/2" pipe and will have a go tommorow. Haven't found unions yet, but will try and salvage the old ones.
 
1 - 4 of 4 Posts
Top