Sorry should of said its the key fob that needs reprogramming as its stopped working , I sourced a new one
Cityrover select learn key port
Hi I was wondering if anyone can help with the above , I can't find the port and need some help reprogramming if possible , thanks
1 - 8 of 8 Posts
Diagnostic connector should be on the passenger side behined/below glove box. You should be able to check by your hand to see if it is there.
Hi I'll have a look thanks, any idea of programming sequence?
It's not , I've found it, for anyone wanting to know it's under the drivers seat on the floor in the carpet openingDiagnostic connector should be on the passenger side behined/below glove box. You should be able to check by your hand to see if it is there.
Unfortunately I do not have info on programming sequence.Hi I'll have a look thanks, any idea of programming sequence?
This is very interesting info...It's not , I've found it, for anyone wanting to know it's under the drivers seat on the floor in the carpet opening
To add new fobs you need the "programming fob" which has a cable attached that is plugged into the alarm/immobiliser module to enable the process.
It isn't something that is done using a diagnostic tool.
I believe a "programming fob" was meant to be supplied with each vehicle from new.
It isn't something that is done using a diagnostic tool.
I believe a "programming fob" was meant to be supplied with each vehicle from new.
1 - 8 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
MG-Rover.org Forums
A forum community dedicated to MG & Rover owners and enthusiasts. Come join the discussion about performance, troubleshooting, upgrades, maintenance, and more!
Full Forum Listing
