MG-Rover.org Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
797 Posts
Discussion Starter · #1 ·
Weather permiting, I will be trying to swap the hatches arround on my two 214s.

Last summer, my dad tried to take the hatch off but said he was unable to pull the wires through, he said they seemed to get caught.

has anyone successfully taken a hatch of a 214 before and had similar problem? If they did, could they tell me what they did to get round it?

Cheers
 

·
Registered
Joined
·
15,938 Posts
take the trim and the trim clips out as the connector gets caught on the clips running up the sides...getting it out is easy, getting it back in a is a pain in the ****!!!!

andy
 

·
Registered
Joined
·
797 Posts
Discussion Starter · #3 ·
AndBurG said:
take the trim and the trim clips out as the connector gets caught on the clips running up the sides...getting it out is easy, getting it back in a is a pain in the ****!!!! andy
Cheers, sorted it! Clips out is defo the way to go!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top