MG-Rover.org Forums banner
wiring
1-11 of 11 Results
  1. MG ZR / Rover 25, 200 & Streetwise
    Hi everyone, recently I bought a Rover Streetwise 2005 1.8, the reverse light isn't working, I found the reverse switch that was broken and I bought a new one but I can't find anywhere the wiring where I have to connect the new reverse switch, someone can tell me where I have to search? Is...
  2. MG ZT / Rover 75
    There's a long story behind this that I won't bore you with, but my Rover 75 Connoisseur currently has a nearly dead instrument panel. Nothing works except the lights in the middle of the console and the odometer (sometimes). This has occurred after some soldering repairs were done to the...
  3. MG ZR / Rover 25, 200 & Streetwise
    Hi All, So I've got round to wiring in a Dual USB Socket in my ZR. I've taken the feed from the existing 12v Aux. Socket. It all works swimmingly, but the USB socket illuminates and it is permanently illuminated, so it seems the aux. feed is permanently live. I'm now worried about it draining...
  4. MG ZS / Rover 45 & 400
    I have run into the problem of trying to put in a new head unit, and instead of actually checking any forums or anything before hand I cut wires and stripped them like an idiot. Will I need to get a whole new loom or is there actually a way I connect these?
  5. MGF and MGTF
    Due to opening and closing of the boot lid, wiring loom attached to boot lid is folding every time. This folding can eventualy lead to breaking of wires within this loom. This breakage can lead to various type of problems from non-operating third brake light to alarm sounding during night...
  6. Introduce yourself
    Hi everyone, I'm currently in the process of a full engine rebuild and I've run across a major electrical issue, yesterday i wound down the passenger window and when I tried to wind it back up it wound up the drivers side window instead so I had to take off the passenger door card and manually...
  7. Blog
    Had a problem with the rear windscreen demister not turning off and was a bit concerned as it would drain the battery when it gets colder if I left it as it was. Posted a question in the R200 area and was advised 'check tailgate loom',. Sure enough: I'd fixed it in the past, but the wires had...
  8. MG ZR / Rover 25, 200 & Streetwise
    I have a converted Rover 214 to a 1.8, I've still kept the 1.4 ECU with the MAP system disconnected to make it over fuel, I want to correct this as now it is pinking, I've been looking at new ECU's and have found converting it to MEMS 3 is too much work as it means changing looms and ignition...
  9. MG ZR / Rover 25, 200 & Streetwise
    Does anyone have a picture of the instrument panel wiring diagram from the rover 200 Haynes manual as I'm in need of one desperately, any help is much appreciated
  10. MG ZR / Rover 25, 200 & Streetwise
    I recently purchased a speedo without abs and i cant get the bugger to work ive searched all over the forums and ive followed all the steps with the reD wire going to orange and white and the black to ground now my only issue is that the speedo doesnt move, im stumped at the moment and have hit...
  11. MG ZR / Rover 25, 200 & Streetwise
    Hi guys ;) The story (skip if you want to) Well my battery ran flat again yesterday, had to get a bump start outside a customer's house (the customer helping to drag my car up the hill so I could start it, not fun)... I assumed it was because I'd let the battery run flat by leaving the...
1-11 of 11 Results
Top