MG ZS 180 VHS Bilstein Dampers (Vehicle handling solutions). £300
These Bilstein Dampers where with the car when purchased and are no longer required.
They where purchased by the pervious owner who covered minmal miles and as a result they are in very good condition.
However one of the front...
I need to change the front right steering knuckle on my 1.4 Rover Streetwise.
Unfortunately the only one's I found here in Hungary are for the 25.
Can I use the (front right) steering knuckles from a 25 for my Streetwise?
Thanks in advance and stay safe!
Just set front suspension with Spax damper Eibach springs following:
With both poly bush with the tapered end down over, I see on the internet everybody fit the bushes in many ways, for example here is...
Well that's phase 1 complete, getting both the subframes from the front of the house to the rear. Cup of tea time now.
Noticed though that they are without the front top arms. So when I ordered "subframe complete with all suspension components" I'm not sure how that could be...
Well I'd been wanting to lower my car for ages but could never afford some decent springs, I was saving up for some SPAX when on here I was looking through the for sale thread and I stumbled accross some AVO 30mm for £70, alot cheaper than the SPAX and I know all you guys rate them quite well...
As the title suggests, my Trophy 160 rear hydragas is really fubar and, as we know, replacements are like rocking horse manure. I've had numerous suggestions about what to do with the car - and some of them were printable. However - I thought I'd check the mass consensus, as I'm sure I...
My rear tyres have always come close to the arches since I put 205/55/R16s on, but on the way to POL with the boot full of stuff, full tank of fuel and a friend on the back seat it was even lower.
Was fine for a while but when I went over a bump there was a lovely noise from the left...
I'm looking urgently for a replacement hydragas pipe for the drivers side of a rover 114. I know it's in my best interests to individualise the suspension but I need the car road-worthy asap and the garage are being incredibly difficult. As such, if anyone has one lying around or...
Am looking for a rear suspension unit (part number NAM9533) for a Rover 114. It's in incredibly good nick and it'd be a tragedy if I had to get it scrapped coz I can't find one. Garage currently can't find the part in stock and I only have a limited time before they want the car off...
As the title suggests I'm after some ZR suspension as an upgrade for my 218. Will need dampers and springs for front and rear.
Ideally after ZR 160 suspension, but I'm happy to consider alternatives if the price is right. I want to lower my car slightly (30-40mm ish) and improve the...
Hi everyone, first thread! woop!
Anyway, a few months ago i hit my r/o/s wheel and ended up bending the metal plate the drum bolts too.
It got pulled out at the top by a few mm and i have countered it bt spacing the bottom out with washers.
I was wondering how hard is it to charge it...
For a while now I've been putting up with a lousy ride and some "unsafe" feelings when driving my F. I.e. steering just doesn't feel right.
She had her clutch and a load of other bits done recently including a drain and refill of the hydragas system. When I got the car back all was...
Rover 25 suspension
Rover 25 grille
Rover 25 seats (5 door)
Rover 25 rear spoiler
MG ZR door cards (3 door
ALL STARTING BIDS 0.99p: NO RESERVATION!
Just click on link below
Any questions please ask
My name is Steve, I have had my MGTF for just over a year, have added a few shiney bits here and there.
I found the ride as described by other TF owners, so I had the comfort pack suspension fitted at the last service.
It did not come from the MGOC, as that one did not come with springs, but...
I have for sale a Stainless Steel exhaust system for a 1994 216i cabriolet with the Honda 'D' series engine. It has an oval end and looks fantastic on the car, as seen in my pics in the cabby gallery. I fitted the backbox to my car to take those pics and then removed it, to fit at a later date...