MG-Rover.org Forums banner
slave
1-3 of 3 Results
  1. MG ZS / Rover 45 & 400
    I drove to work this morning with a ton of stop start traffic and my gears were getting harder to engage then just as i got to work the plastic flange of the slave cylinder snapped and the clutch pedal fell to the floor as the slave rod popped off the clutch arm!! Does anyone know if there is...
  2. MGF and MGTF
    Hi All, Replaced the seal on my slave cylinder this week, bled and repressurised system using Gunsons kit. Put my foot on clutch, brake fluid comes shooting out the cylinder around the seal!!! I can lightly pump the clutch and build up some pressure again but as soon as I press the pedal...
  3. MGF and MGTF
    Hi, Did the repair on the slave clutch cylinder today. Think I've done it right after a lot of swearing and sweating. The knackered seal in the piston jammed half out so had to remove the slave cylinder housing first as I couldn't get the clevis pin arrangement out. Grr. As a result of all...
1-3 of 3 Results
Top