Search Results for ‘repair’

I’m about to buy a 98 S plate F that’s been in my car park forever as a bit of a project. It’s got a fair bit of rust on the cat and I’m guessing whole underside. Body work is great with the exception of a few dents on the skirts. Interior is moulded through but with no rips tears. Engine looks...

Greetings Rover guru's, Recently i have been trying to remove the instrument panel surround to get to some burnt out instrument bulbs, yet the manual has not been enough for me to be succesful it states that 4 screws should be removed and 2 clips should be released, yet it doest tell or show me...

Hi, Had an MOT failure for rust on the offside Sill being within 30 cm of the suspension mounting - I think this may be a common problem with Rover's in general I know a friend of mine had his 75 needing the Sill replaced. My question is, is this an expensive procedure to get this cut out and...

Hello everyone, I work as a software engineer in my day job, on a daily basis I mostly handle security and industrial communication tasks. Besides my day-job, I am an embedded hobbyist, a radio amateur and I try to make things in my nearly non-existent spare time (I struggle to be a maker)...

Found another problem on my newly acquired Rover 25: the coolant level dropped and a look underneath revealed a drop of coolant under the sump. I had a good look around, including taking blind photos with the camera, and saw the IMG looked suspect with signs of leaking coolant. I...

Hi guys. Just recently purchased my Rover 45 MK1 in Starlight Silver and it has a couple of bruises I'd like to repair. First and most annoying one is this little dent in the front passenger door: Could I maybe push that out from the inside? Or is it a bigger job... Also have a couple of...

Symptom - clock, instrument and lights flickering. Varying voltage across battery terminals when engine running. Decided to replace regulator/ brush assy - re. earlier thread: Lights flicker when engine runs I thought this would be an easy job, but the designers must have been having a laugh...

Hi, Did the repair on the slave clutch cylinder today. Think I've done it right after a lot of swearing and sweating. The knackered seal in the piston jammed half out so had to remove the slave cylinder housing first as I couldn't get the clevis pin arrangement out. Grr. As a result of all...

I am After a cheep rear bumper in silver for my MG TF, anyone know of where to get on in the Staffordshire area? Or can anyone suggest where to get it fixed and resprayed, only problem being the crush can is damaged and the bumper has a spilt in it to. Would it just be better to get a second...

I've had my old Rover 600 Diesel sitting around for a few months since it went pop, waiting for me to get round to doing something with it. Unfortunately the council has now noticed this and I have until Friday to remove it. Before I send it to a scrappy I thought I’d post on here (my go-to...