MG-Rover.org Forums banner
removal
1-2 of 3 Results
  1. Blog
    Once these are out, just pull the plastic shroud away, but it'll probably pop off when the final nub is out. You're left with removing two bolts per side, and the seat belt retainer. Use the T50 Torx bit on each of the bolts. They're torqued up, but a quality bit won't have any problems at...
  2. Blog
    This is an easy swap, once you get the four bolts out to remove the actual seat from the car (these can be really corroded and stuck - get a Teng/Snap On torx bit, don't use cheap stuff that will strip the head). All the bolts are T50 torx bolts. You'll need a small screw driver to remove the...
1-2 of 3 Results
Top