MG-Rover.org Forums banner
induction
1-2 of 2 Results
  1. Blog
    I noticed my air-intake Shannon tube was falling apart so looked up the fix on this forum in the R75/ZT common questions area. I ordered the parts, 70mm dia neoprene air-duct flexible-tube and a couple of jubilee clips, and followed the instructions. This is the state of my old Shannon tube...
  2. MG/R Modification & Tuning
    Hi all, I am going to fit a smallish air intake scoop into my bonnet above the induction kit ( well slightly to the side actually ). Is there anyone here that can tell me whether I should place a heat vent to allow for better throughflow and heat extraction on the bonnet too? and if so, where is...
1-2 of 2 Results
Top